G-DEMPack manual

From KratosWiki
Revision as of 14:47, 21 August 2015 by Maceli (Talk | contribs)
Jump to: navigation, search

This manual explains how to run a DEM simulation with D-DEMPack on GiD.


Loading D-DEMPack

If you did not install GiD or D-DEMPack yet, follow the installation instructions here: D-DEMPack installation

Once you have finished the installation, open GiD and load the D-DEMPack Problemtype by clicking:

Data -> D-DEMPack

Note that a toolbar with 7 buttons has been added to the left side of the GiD working window. This toolbar is called "Model definition toolbar" and can be hidden and shown through the GiD utilities:

Utilities -> Tools -> Toolbars

The buttons in the Model definition toolbar do the following actions:

Button 1 - Link to the GiD Groups Management Window

Button 2 - Model Definition Menu

Button 3 - Materials Menu

Button 4 - Running Processes Management Window

Button 5 - Run this case

Button 6 - Show information about how this case is running

Button 7 - Stop this case

The GiD philosophy

GiD is a Pre and Post Processor, it is not an actual CAD tool. However, it can be used to draw geometries and mesh them. For complicated geometries, we reccomend using a CAD tool and importing them into GiD for meshing (or import mesh and apply conditions directly). In case of drawing geometries with GiD, one must be aware that it uses a Hierarchical Structure: Volumes are created with a set of watertight Surfaces, Surfaces are created with a set of watertight Lines and Lines are created starting and ending in Points. If there are no Points, a Line cannot be created, and the same dependence holds for all levels. For more information about how to use GiD, visit GiD's home page or follow some tutorials

The Kratos philosophy

The way Kratos applies materials and conditions to the geometry or the mesh is using the Groups. A Group is a set of entities (either in Geometry or in Mesh). A Group can contain any Volume, Surface, Line, Point, Element or Node, no matter whether it is already belonging to other Groups.

The D-DEMPack philosophy

Since DEMPack is based in Kratos and programmed for GiD, it inherits the philosophy of both. The Groups will be the essential tool for assigning materials and conditions.

OPTION 1: Use the Groups Management Window to create Groups and move entities into the corresponding Groups. Go to the Model Definition Tree, fill in all the fields and assign conditions to existing Groups (the ones you just created).

OPTION 2: Fill in all the fields of the Model Definition Tree and when asked for any Group to assign the condition to, use the button for automatic creation of Groups (included in the mini window for condition assignation)

Personal tools